Cover Page June-2015-Advanced Materials Letters

Advanced Materials Letters

Volume 6, Issue 6, Pages 513-517, June 2015
About Cover


 Structural, Optical And Electrical Properties Of Cu(InGa)SeTe Device With The Varying Laser Pulses

Abhay Kumar Singh1, 2*, R. Ganesan2, Jong Tae Park1 

1Department of Electronics Engineering, Incheon National University, South Korea 460772

2Department of Physics, Indian Institute of Science, Bangalore 560012, India 

Adv. Mater. Lett., 2015, 6 (6), pp 513-517

DOI: 10.5185/amlett.2015.5774

Publication Date (Web): May 28, 2015

E-mail: abhaysngh@rediffmail.com

Abstract

Next-generation high-performance heterojunction photovoltaic (PV) modules can be fabricated with an appropriate active layer material. Therefore, it is worth to examine physical properties of the recent developed Cu25(In16Ga9)Se40Te10 (CIGST) material for the potential photovoltaic application. This, report demonstrates the structural, optical and electrical properties of the 8000 and 16000 pulses deposited CIGST films on top of the ITO coated soda lime substrate (CIGST/ITO/substrate); whereas, the substrate temperature was 5500 C. The 16000 pulses deposited thin film surface roughness (45 nm) and thickness (~1.4 μm) are obtained lower and higher than the 8000 pulses thin film. The cross sectional EDS elemental mapping also gives the fewer interlayer inclusions for the 8000 pulses deposited thin film. With the increasing thin films thicknesses a distinguishable UV/Visible peak shift toward the high wavelength side and enhance in optical energy band gap (1.13 and 1.2 eV) are noticed. Device fabricated (CIGST/ITO/substrate) with the 16000 pulses have a sharp current growth upto 2.0 × 10-2 amp with a lower resistance under the applied voltage range 0-20V. The internal (IQE) and external (EQE) quantum efficiencies charge carriers transport for the fabricated devices are also discussed.

Keywords

CIGST, PLD, thin films, optical property.

Previous issues

Cloud Medicine set to Revolutionize Doorstep Personalized Healthcare

Various surfactants for 0 – 3 dimensional nanocarbons: Separation, exfoliation and solubilization

Polypyrrole based biofunctional composite layer for bioelectrocatalytic device system

Innovative Graphene-PDMS sensors for aerospace applications 

Effect of hot drawing process and carbonization temperature in electrochemical behavior of electrospun carbon nanofibers

Chemical Reactivity and Electronical Properties of Graphene and Reduced Graphene Oxide on Different Substrates

Laser Raman micro-spectroscopy as an effective non-destructive method of detection and identification of various sp2 carbon modifications in industry and in nature

Electrochemical promotion of ammonia synthesis with proton-conducting solid oxide fuel cells

Biomimetic surfaces with hierarchical structure using microsized texture and nanosized Cu particles for superhydrophobicity

Enhancement the properties of high and low-density polyethylene membranes by radiation grafting process

Synthesis of 9-Aminoacridine and its Application as an Anode Material for Aqueous Rechargeable Lithium–ion Batteries

Facile synthesis of novel tough and highly flexible biodegradable membranes for water microfiltration

Investigating the possibility of using acetic acid in place of HF in chromium-benzenedicarboxylates (MIL-53 and MIL-101) synthesis applicable for CO2 adsorption

Upcoming Congress

Knowledge Experience at Sea TM