Cover Page November-2018-Advanced Materials Letters

Advanced Materials Letters

Volume 9, Issue 11, Article ID 816-822, November 2018
About Cover

Cover page describe the Typical fracture surface of nuclear graphite blocks after irradiation (cracks occur during reactor operation). This picture Summarize the Fractographic studies of GR-280 nuclear graphite after irradiation up to neutron fluence above the turnaround dose (with a decrease in of the mechanical properties to the values close to the initial one after primary radiation-induced increase) showed along with the presence of transcrystalline fracture, appearance of intercrystalline fracture regions along the “filler-binder” type boundaries.


Staking lay-up effect on dynamic compression behaviour of e-glass/epoxy composite materials: experimental and numerical investigation

Mostapha Tarfaoui1, 2*, Mourad Nachtane1, 3

1ENSTA Bretagne, IRDL - UMR CNRS 6027, F-29200 Brest, France

2University of Dayton, Nanomaterials Laboratory, Dayton, OH 45469-0168, United States

3Laboratory for Renewable Energy and Dynamic Systems, FSAC - UH2C, Morocco

Adv. Mater. Lett., 2018, 9 (11), pp 816-822

DOI: 10.5185/amlett.2018.2060

Publication Date (Web): Jul 25, 2018

E-mail: mourad.nachtane@gmail.com

Abstract


Several industrial applications have exposed polymer matrix composite materials to a very high strain rate loading conditions, requiring an ability to understand and predict the material behaviour under these extreme conditions. Many composite aircraft structures such as fuselage, wing skins, engine nacelles and fan blades are situated such that impacts at high strain rates are a realistic threat. To investigate this threat, high velocity impact experiments and subsequent numerical analysis were performed in order to study the compressive loading of composite materials at high strain rates. Specimens are subjected with various orientations from low to high strain rates to determine the compressive material properties. Three fibre orientations such as: ±20°, ±60° and 90° of cubic geometry are tested in in-plane direction. The tests show a strong material sensitivity to dynamic loading and fibre direction. In the second part, the FEA results of the dynamic tests resulting in no damage appeared satisfactory. The FEA gives results which are in coherence with the experimental data. The improved understanding of these phenomena and the development of predictive tools is part of an ongoing effort to improve the long-term integrity of composite structures under dynamic loads.

Keywords

Composites, dynamic compression, experimental approach, finite element modelling.

Current Issue
The Journey of a Decade to Advancing Materials
Are the Electrospun Polymers Polymeric Fibers?
Mechanical and Thermal Properties of Composite Material and Insulation for a Single Walled Tank for Cryogenic Liquids
Prediction of Long-Term Behavior for Dynamically Loaded TPU
Investigation of Doped Titanium Dioxide in Anatase Phase. Study ab initio using Density Functional Theory
Comparison between Single Al2O3 or HfO2 Single Dielectric Layers and their Nanolaminated Systems
Preparation of Stable and Optimized Antibody-gold Nanoparticle Conjugates for Point of Care Test Immunoassays
Resonance-Based Temperature Sensors using a Wafer Level Vacuum Packaged SOI MEMS Process
Integrated System Based on the Hall Sensors Incorporating Compensation of the Distortions
The Efficacy of Cinnamomum Tamala as a Potential Antimicrobial Substance against the Multi-Drug Resistant Enterococcus Faecalis from Clinical Isolates
The Effect of Complexing Reagent on Structural, Electrical and Optical Properties of CuS Thin Film
Laser Cladding of Fluorapatite Nanopowders on Ti6Al4V
Preparation and Evaluation of Sulfonate Polyethylene Glycol Borate Ester as a Modifier of Functional Properties of Complex Petroleum Lithium Grease

Upcoming Congress

Knowledge Experience at Sea TM