Cover Page August-2018-Advanced Materials Letters

Advanced Materials Letters

Volume 9, Issue 8, Article ID 549-552, August 2018
About Cover

Investigation on stability and photocatalysis of perovskites 

Yidi Wang, Pui Fai NG, Bin Fei

Institute of Textiles & Clothing, Hong Kong Polytechnic University, Hong Kong, China

Adv. Mater. Lett., 2018, 9 (8), pp 549-552

DOI: 10.5185/amlett.2018.1911

Publication Date (Web): Jun 14, 2018



Hybrid organic–inorganic perovskite materials have attracted a lot of attention with their facile synthesis process and high efficiency of light absorption. However, poor stability is always a big barrier to commercial development. In this study, a new kind of organic perovskites MA0.6(AA)0.4PbBr3 (AM-PE), which harnesses aniline as a replacement of conventionally used methylamine, was synthesized to increase the stability of MAPbBr3 (M-PE). The decomposition process of MAPbBr3 in acetone was investigated. Smaller PbBr2 particles were formed in the decomposition process, causing the change of photoluminescence emission wavelength from 540 nm to 610 nm. The photocatalysis and photoluminescence properties of M-PE and AM-PE were also compared. As a result, the introduction of aniline reduced the decomposition rate of AM-PE significantly and showed twice the catalysis efficiency of M-PE in the degradation of organic dye - malachite green.


Perovskite, photocatalysis, stability, photoluminescence.

Current Issue
The Journey of a Decade to Advancing Materials
Are the Electrospun Polymers Polymeric Fibers?
Mechanical and Thermal Properties of Composite Material and Insulation for a Single Walled Tank for Cryogenic Liquids
Prediction of Long-Term Behavior for Dynamically Loaded TPU
Investigation of Doped Titanium Dioxide in Anatase Phase. Study ab initio using Density Functional Theory
Comparison between Single Al2O3 or HfO2 Single Dielectric Layers and their Nanolaminated Systems
Preparation of Stable and Optimized Antibody-gold Nanoparticle Conjugates for Point of Care Test Immunoassays
Resonance-Based Temperature Sensors using a Wafer Level Vacuum Packaged SOI MEMS Process
Integrated System Based on the Hall Sensors Incorporating Compensation of the Distortions
The Efficacy of Cinnamomum Tamala as a Potential Antimicrobial Substance against the Multi-Drug Resistant Enterococcus Faecalis from Clinical Isolates
The Effect of Complexing Reagent on Structural, Electrical and Optical Properties of CuS Thin Film
Laser Cladding of Fluorapatite Nanopowders on Ti6Al4V
Preparation and Evaluation of Sulfonate Polyethylene Glycol Borate Ester as a Modifier of Functional Properties of Complex Petroleum Lithium Grease

Upcoming Congress

Knowledge Experience at Sea TM