Cover Page July-2018-Advanced Materials Letters

Advanced Materials Letters

Volume 9, Issue 7, Article ID 505-509, July 2018
About Cover


Thermal properties of hydrogel-clay nano-composites

Romina P. Ollier*, Laura M. Sanchez, Jimena S. Gonzalez and Vera A. Alvarez

Materiales Compuestos Termoplásticos (CoMP), INTEMA (CONICET-Universidad Nacional de Mar del Plata). Av. Colón 10890, Mar del Plata, B7608FLC, Argentina

Adv. Mater. Lett., 2018, 9 (7), pp 505-509

DOI: 10.5185/amlett.2018.2047

Publication Date (Web): Jun 14, 2018

E-mail: rominaollier@fi.mdp.edu.ar

Abstract


Hydrogels are one of the most widely employed materials in biological, medical and technological areas. However, the use of hydrogels sometimes is restricted due to their specific properties. It is well-known that polymeric nanocomposites reinforced with clays show valuable improvements in their properties. In this work, eco-friendly composite hydrogels were prepared employing polyvinylalcohol (PVA) and bentonite (abundant and low cost smectite-type clay in Argentina) as raw materials through the previously optimized freezing-thawing (F-T) crosslinking method. Different nanocomposite hydrogels were obtained by varying the corresponding reactor feed. These materials have been recently chemically, morphologically and mechanically analysed in a recent work. Specifically, in the present work, thermal degradation behaviour of PVA-bentonite hydrogels was studied. Kinetic analytical models were applied to non-isothermal thermogravimetric (TGA) measurements trying to identify the possible mechanism for PVA degradation in the presence of bentonite.

Keywords

Hydrogel, bentonite, thermal properties.

Current Issue
The Journey of a Decade to Advancing Materials
Are the Electrospun Polymers Polymeric Fibers?
Mechanical and Thermal Properties of Composite Material and Insulation for a Single Walled Tank for Cryogenic Liquids
Prediction of Long-Term Behavior for Dynamically Loaded TPU
Investigation of Doped Titanium Dioxide in Anatase Phase. Study ab initio using Density Functional Theory
Comparison between Single Al2O3 or HfO2 Single Dielectric Layers and their Nanolaminated Systems
Preparation of Stable and Optimized Antibody-gold Nanoparticle Conjugates for Point of Care Test Immunoassays
Resonance-Based Temperature Sensors using a Wafer Level Vacuum Packaged SOI MEMS Process
Integrated System Based on the Hall Sensors Incorporating Compensation of the Distortions
The Efficacy of Cinnamomum Tamala as a Potential Antimicrobial Substance against the Multi-Drug Resistant Enterococcus Faecalis from Clinical Isolates
The Effect of Complexing Reagent on Structural, Electrical and Optical Properties of CuS Thin Film
Laser Cladding of Fluorapatite Nanopowders on Ti6Al4V
Preparation and Evaluation of Sulfonate Polyethylene Glycol Borate Ester as a Modifier of Functional Properties of Complex Petroleum Lithium Grease

Upcoming Congress

Knowledge Experience at Sea TM